ACT DD7930 Network Cable Cat6a U/UTP Patch Cable 0.15 m RJ-45 Black

ACT DD7930 is a 0.15 m Cat6a U/UTP slimline patch cable with RJ-45 connectors angled 90° down to 90° up. The cable uses 28AWG full copper conductors, 50µ gold-plated RJ45 contacts and an LSZH jacket, and is intended for short patching runs in racks, switches, patch panels and workstations where space is limited and airflow is important.

Advantages

The slimline design has a reduced outer diameter of 3.6 mm compared with standard Cat6a cords, offering a smaller bend radius and improved airflow inside server racks and network cabinets. Gold-plated contacts and full copper conductors provide reliable electrical contact and signal integrity. The LSZH jacket lowers the risk of releasing high concentrations of toxic gases in case of fire or cable damage.

Suitable for

When it may not be suitable

This 0.15 m cable is intended for very short interconnections; it is not suitable when longer reach or cable routing over distance is required. Environments that demand armored or outdoor-rated cables are better served by products specifically designed for those conditions.

Key specifications

How to use

Plug each RJ45 connector into the appropriate port on switches, patch panels or devices, ensuring the 90° orientation matches the space constraints behind equipment. Use this cable for short patch connections inside racks or between closely positioned devices; avoid excessive bending beyond the cable's bend radius despite the slim profile.

What to consider before purchase

Recommendations

For best results in dense rack environments use the slim 3.6 mm cable to maintain airflow and route connectors so the angled ends avoid sharp bends; verify connector orientation matches port layout before installation.