ACT Mains Cable Euro Plug - C7 Socket (Angled) Black 2 m

The ACT Power cord Euro male - C7 female angled down black 2 m ACT is a mains cable with a Euro (CEE7/16) male plug and a C7 female (figure-8) coupler. Its 2 m length and angled-down female end are designed to connect audio-visual equipment, small appliances and laptop power adapters where space is limited or where a low-profile rear connection is needed. The cable supports up to 250 V input and comes in black for a discreet appearance in home and office environments.

Advantages

The angled-down C7 connector reduces strain on device inlets and allows placement close to walls or low-clearance furniture. A 2 m length provides additional reach compared with short appliance leads while remaining manageable and easy to route. The Euro male (CEE7/16) plug is widely compatible with standard European mains sockets, and the simple figure-8 coupler fits many consumer electronics that use two-pin, non-polarised power inlets.

Suitable for

• Portable audio equipment and small stereos
• DVD/Blu-ray players and set-top boxes
• Some laptop power bricks and chargers with C7 inlets
• Printers, scanners and other small office electronics with figure-8 inlets
• Installations where a low-profile or angled connection is required

Key specifications

• Connector 1: Euro male (CEE7/16)
• Connector 2: C7 female (figure-8), angled down
• Cable length: 2 m
• Rated input voltage: 250 V
• Colour: Black

How to use

Ensure the device to be connected uses a C7 inlet and is rated for the cable's input voltage. Insert the Euro male plug into a compatible mains socket and connect the angled C7 coupler firmly to the device's figure-8 inlet. Route the cable to avoid sharp bends and reduce mechanical strain on the angled connector. Disconnect by pulling the plug or coupler body, not the cord, to preserve connector integrity.

Recommendations

Use the cable in dry, indoor environments and avoid exposure to liquids or extreme temperatures. Inspect the cord regularly for wear or damage and replace it if the insulation or connectors show signs of deterioration. Do not attempt to modify the cable or connectors; if a different plug standard or length is required, obtain a suitable certified replacement cable.