Akasa AK-CB050 SATA Cable for Slimline Drives

The Akasa 20cm SATA cable for slimline opticals Akasa AK-CB050 is a compact internal data cable designed to connect slimline optical drives to standard power sources in small-form-factor systems. With a 0.2 m length and a Molex 4-pin connector, the cable provides a tidy, short run suitable for tight internal layouts. The red jacket aids visual identification during installation and maintenance, while the single-unit packaging supports straightforward replacement or upgrade of internal optical drive connections.

Advantages

This slimline SATA cable offers a short, flexible connection that reduces cable clutter inside compact cases. The Molex 4-pin connector provides wide compatibility with older power supplies and adapters commonly used for slimline optical drives. Its 0.2 m length is useful for neat routing in mini-ITX, HTPC and compact desktop enclosures. The cable's lightweight construction and distinct red color make it easy to handle and identify during assembly.

Suitable for

• Connecting slimline optical drives in compact desktop PCs
• HTPC and small-form-factor system builds
• Repairing or replacing internal slimline drive power cables
• Systems where short cable runs and tidy cable management are required

Key specifications

• Cable length: 0.2 m
• Connector type: Molex 4-pin (power)
• Intended use: slimline optical drive power connection
• Colour: Red
• Weight: 0.02 kg

How to use

Power down the system and disconnect it from mains power before installation. Open the case and identify the slimline optical drive power port and an available Molex 4-pin power output from the power supply or adapter. Align the Molex 4-pin connector with the power source and press gently until it seats securely, then connect the slimline end to the optical drive. Verify correct orientation and cable routing to avoid interference with fans or moving parts, then close the case and restore power to test the drive operation.

Recommendations

Use this short SATA cable where a concise, direct power connection is needed inside compact enclosures; avoid excessive bending near the connectors and ensure connectors are fully seated before powering the system.