Fibre optic transceiver module BlueOptics J9151ECM-BO SFP+ 10000 m

The BlueOptics J9151ECM-BO SFP+ 10000 m is a fiber optic transceiver module designed for 10G high-speed optical links. It implements the 10GBASE-LR single-mode specification with LC duplex connectivity and supports transmission distances up to 10,000 meters. The module is housed in a lightweight aluminium enclosure and complies with common MSA form-factor and electrical interface requirements for SFP+ ports.

Advantages

The transceiver provides 10 Gbit/s data throughput over single-mode fiber with separate 1310 nm transmitter and receiver wavelengths, enabling simultaneous send and receive operation. Constructed from aluminium and weighing approximately 20 g, the module offers a compact, durable solution for dense networking environments. It is designed and tested for compatibility with major vendor platforms that support equivalent 10GBASE-LR SFP+ modules and includes digital diagnostics monitoring (DDM/DOM) support for real-time status reporting of supply voltage, laser bias current, transmit power, receive power and temperature.

Suitable for

Key specifications

How to use

Install the module into an available SFP+ slot on a compatible switch, router or storage device following the host hardware instructions. Connect an LC duplex single-mode patch cable to the module and the corresponding remote transceiver or patch panel. Ensure that the host device firmware or software supports third-party transceivers if applicable. Monitor link status and transceiver parameters through the host management interface using the DDM/DOM features where supported.

Recommendations

Use single-mode fiber with appropriate attenuation characteristics and LC duplex connectors to achieve the full 10 km range. Keep firmware and device drivers up to date and verify DDM/DOM readings during commissioning and periodic maintenance to detect signal degradation early. For best results in data centers and enterprise networks, pair this transceiver with clean, tested fiber patch cords and follow vendor guidelines for ESD and handling.