Nailer/stapler Dedra DED7053, 100 shots/min, 18V

The Dedra DED7053 18V nailer/staple gun is a battery-powered fastening tool designed for quick and cordless operation. Capable of firing up to 100 shots per minute, it accepts staples up to 40 mm and nails up to 50 mm, and weighs approximately 2.8 kg. The tool is intended for assembly, upholstery, light carpentry and general fastening tasks where mobility and speed are required.

Advantages

The battery-powered design provides freedom from cables and enables use in locations without mains power. With a firing rate of up to 100 shots per minute, the tool supports efficient work on repetitive fastening jobs. Its compact weight of around 2.8 kg helps reduce operator fatigue during extended use. Support for both staples and nails makes the tool versatile across different materials and applications.

Suitable for

• Furniture assembly and upholstery work
• Interior trim, moulding and skirting installation
• Light carpentry and framing tasks
• Insulation and panel fastening
• General repair and DIY fastening projects

Key specifications

• Power source: 18V battery
• Maximum firing speed: 100 shots per minute
• Compatible staple length: up to 40 mm
• Compatible nail length: up to 50 mm
• Weight: approximately 2.8 kg
• Functionality: supports both stapling and nailing

How to use

Before use, install a charged 18V battery according to the manufacturer's instructions and load the appropriate staples or nails matching the specified lengths. Position the tool's nose against the work surface and press the safety contact if required, then squeeze the trigger to drive a staple or nail. For repeated fastening, maintain a steady hand and consistent contact pressure to ensure uniform depth and placement. After use, remove the battery and store the tool in a dry place.

Recommendations

Use fasteners within the supported length ranges and select staples or nails appropriate for the material being worked on. Wear eye protection and follow standard safety practices for power fastening tools. For best results on trim and upholstery, perform a test drive on scrap material to adjust positioning and confirm correct fastener length and holding power.