Schwaiger CKB6010 059 network cable, RJ-45 Cat6, 1 m, green

The Schwaiger CKB6010 059 networking cable is a Cat6 copper patch cable in a 1 m length with RJ-45 connectors on both ends. Constructed with SF/UTP (S-FTP) shielding, the cable reduces electromagnetic interference and crosstalk while maintaining consistent signal quality. Rated for Gigabit Ethernet speeds, this green cable is suitable for connecting routers, switches, network interfaces and other Ethernet-enabled devices where a short, shielded link is required.

Advantages

SF/UTP (S-FTP) shielding provides improved protection against external electromagnetic disturbance compared with unshielded cables, helping to preserve throughput and reduce retransmissions. The Cat6 specification supports reliable Gigabit performance for typical LAN and home networking tasks. Pre-terminated RJ-45 plugs on both ends allow immediate plug-and-play installation. The 1 m length reduces cable clutter for close-proximity connections, and the coloured sheath makes cable routing and identification easier in crowded installations.

Suitable for

• Connecting a desktop or laptop to a network switch or router over short distances
• Patch panel to switch connections in home or small office racks
• Linking network devices where reduced interference is needed (near power supplies or other cables)
• Temporary or permanent in-desk and equipment cabinet connections where visible cable colour aids organization

Key specifications

• Cable category: Cat6
• Shielding: SF/UTP (S-FTP)
• Connectors: RJ-45 to RJ-45, pre-terminated
• Length: 1 m
• Colour: Green
• Supported data rate: up to 1000 Mbit/s (Gigabit Ethernet)

How to use

Plug one RJ-45 connector into the Ethernet port of your network device and the other into the corresponding port on a router, switch or wall outlet. Ensure both connectors are fully inserted until the latch clicks and test the network link using device indicators or network diagnostics. For best performance, avoid tightly coiling the cable or running it parallel and close to power cables for extended lengths; maintain gentle bends and avoid sharp kinks.

Recommendations

Use this 1 m shielded Cat6 cable for short interconnects within racks, desks and equipment cabinets. For longer runs or installations that require in-wall routing, select appropriate cable types and installation practices compliant with local regulations. If you experience intermittent link issues, check connector seating and inspect for visible damage to the sheath or plugs.