SFP+ transceiver Lanview MO-R9D17A 10GbE — optical 10 Gbit/s module

Lanview MO-R9D17A is a 10GbE SFP+ transceiver designed for high-speed optical network links and compatibility with HPE interfaces. The compact hot-pluggable SFP+ form factor delivers 10 Gbps connectivity for switches, routers and network interface cards, enabling straightforward upgrades or replacements in data centers, server rooms and enterprise networks. The module supports long-distance optical transmission using standard single-mode fiber and fits into existing SFP+ slots to provide reliable 10GbE optical links.

Advantages

The module provides a standardized SFP+ interface that simplifies installation and hot-swap replacement without powering down equipment. Its optical design offers stable 10 Gbps throughput with low latency, suitable for backbone and aggregation links. The compact form factor reduces space requirements in patch panels and network equipment. Compatibility with commonly used HPE-compatible transceiver ports ensures interoperability with a wide range of enterprise network hardware.

Suitable for

• Upgrading access layer or aggregation switches to 10GbE
• Establishing optical uplinks between switches in data centers
• Connecting servers or storage controllers requiring 10 Gbps optical links
• Replacing faulty or end-of-life SFP+ optical modules in enterprise networks

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbps
• Media type: optical, single-mode fiber
• Typical transmission distance: compatible with long-reach single-mode links (dependent on fiber and transceiver variant)
• Connector type: LC duplex
• Power consumption: low-power SFP+ class device
• Operating temperature range: industrial/commercial ranges depending on deployment

How to use

Install the SFP+ transceiver into an available SFP+ slot on the switch, router or network card until it clicks into place. Connect LC duplex single-mode fiber cables to the module, ensuring correct transmit/receive orientation. After installation, verify link status and negotiated speed using device management interfaces or LEDs on the equipment. If replacing an existing module, remove the old transceiver by releasing the latch and pulling it straight out, then insert the new module following the same steps.

Recommendations

Use clean, inspected single-mode fiber with matching connectors and observe manufacturer guidelines for ESD-safe handling. Verify optical power budgets and link budgets for the specific fiber run and consider using attenuators if necessary. Confirm interoperability with your switch or router firmware and check link status after installation to ensure stable 10GbE operation.