Tecline 15 m Cat.6 Network Cable Yellow

The Tecline 15m Cat.6 networking cable is a 15-meter unshielded twisted pair (U/UTP) Ethernet cable built to the Cat6 standard with RJ-45 connectors on both ends. Its design supports high-speed data transmission for wired networks and the bright yellow jacket provides visual identification in multi-cable environments. The cable is intended for typical home and office networking where reliable wired connections are required.

Advantages

This Cat.6 cable provides consistent performance for gigabit Ethernet and lower-latency wired connections compared with older cable categories. The 15 m length balances reach and signal integrity for common room-to-room or office-to-closet runs, and the U/UTP construction keeps the cable flexible and easy to route. Factory-terminated RJ-45 plugs offer plug-and-play installation without additional tooling, while the yellow outer jacket simplifies cable management and identification.

Suitable for

• Gigabit Ethernet (LAN) connections between switches, routers and endpoints
• Wired connections for desktop PCs, NAS devices and gaming consoles
• Patch panel to wall-port cabling in small offices and homes
• Temporary or permanent runs where visible identification is beneficial

Key specifications

• Category: Cat6 (supports up to 1 Gbps over typical distances and improved performance for higher frequencies)
• Length: 15 meters
• Conductor type: Unshielded twisted pair (U/UTP)
• Connector: RJ-45 on both ends, factory-terminated
• Jacket color: Yellow for easy identification

How to use

Connect one RJ-45 plug to the network device (router, switch or wall socket) and the other to the endpoint device (PC, NAS, console or access point). Ensure both connector clips click into place to confirm a secure connection. Route the cable avoiding sharp bends, heat sources and heavy compression to preserve signal quality and mechanical integrity. For structured cabling, align the cable run with existing pathways and secure with cable ties or clips designed for network cabling.

Recommendations

For best performance, avoid running the U/UTP cable parallel and in close proximity to mains power lines; cross them at right angles if necessary. Test connections with a network tester after installation to verify continuity and link speed. If longer runs, higher shielding or future 10 Gbps requirements are anticipated, consider upgrading to shielded Cat6a or higher-category cabling.