Televes 380210 F-type coaxial plug

The Televes 380210 F-type coaxial connector is a pack of 50 precision-made connectors intended for use with standard coaxial cables in television, satellite and broadband installations. Each connector is engineered to deliver consistent electrical contact and low signal loss, providing a stable interface between coax cable and devices such as TVs, set-top boxes, modems and splitters. The pack format ensures an ample supply for multiple terminations during installation or maintenance tasks.

Advantages

These F-type connectors offer reliable mechanical and electrical performance with easy-to-attach installation. Their construction supports good impedance matching and minimal signal degradation across typical RF frequency ranges used in home and professional coaxial systems. Supplied in a quantity of 50, the pack reduces the need to reorder frequently and is suitable for batch projects or service vehicles.

Suitable for

• Television antenna and cable TV installations
• Satellite LNB and receiver connections
• Home broadband modem and gateway terminations
• Repair and maintenance of coaxial cable runs
• Professional installation kits and DIY projects

Key specifications

• Connector type: F-type male for coaxial cable termination
• Quantity: 50 pieces per pack
• Compatibility: standard RG6/RG59 coaxial cables and similar
• Contact type: threaded connection for secure mechanical fastening
• Intended use: RF signal transmission for TV, satellite and broadband

How to use

Prepare the coaxial cable by stripping the outer jacket, folding back the braid and trimming the dielectric to the correct length for the connector. Slide the connector onto the cable until the center conductor seats in the pin and the dielectric abuts the connector body; then secure the connection by tightening the threaded coupling to the corresponding device or adaptor. Follow standard practice for cable preparation and ensure the connector is fully threaded to avoid signal loss or intermittent connections.

Recommendations

Use appropriate cable strippers and a torque wrench or hand-tighten to manufacturer-appropriate torque values where specified. Inspect each termination for exposed braid or shorts before powering equipment. Store connectors in a dry environment to prevent corrosion and maintain performance over time.